Beechnutt
08-10-2008, 01:06 PM
I had noticed stalling during my break-in procedures of my SE 106. I have a Mercury 350 on a 21 ft Formula. When I first came up on step, I had to come up slow or I would stall. Once the unit was warm (far beyond the normal operating temp of the engine was achieved), I had no problems. During break-in, does the unit put an increased load on the engine?
As the day went on, stalling lessened, but the next day, I still had to wait until the lower unit warmed up before to alleviate the stalling. Will this lessen as the unit breaks in?
As the day went on, stalling lessened, but the next day, I still had to wait until the lower unit warmed up before to alleviate the stalling. Will this lessen as the unit breaks in?